User Category Permission
Technicians Allowed
Printing Configuration Parameters
Shows the values of configuration parameters.
config_get [ name=Name ]
Parameters:
Name Type Description Mandatory Default
name String Name of
parameter to print.
N All parameters.
Id Name Default Position
name Name 1
value Value 2
This command shows the name and value of the specified configuration parameter
or of all of them, if no parameter is provided.
The values of the following parameters can be shown:
v dns_primary- IP address of the master DNS server.
v dns_secondary - IP address of the slave DNS server.
v email_reply_to_address - Reply-to address to be used when sending emails. This
is useful for troubleshooting errors in email addresses.
v email_sender_address - Email address used as the sender's address when sending
email messages.
v email_subject_format - Controls the formatting of the email subject line. The tags
{severity}, {description} and {system_name} can be used to insert the event's
data. System default is "{severity}: {description}"
v iscsi_name - iSCSI initiator name. Used when configuring non-XIV system for
Data Migration over iSCSI.
v machine_model -
v machine_serial_number -
v machine_type -
v ntp_server - IP address or DNS name of the NTP server.
v snmp_community - community used for SNMP queries of the system.
v snmp_location - SNMP location as shown in the SNMP MIB. (.1.3.6.1.2.1.1.6.0).
v snmp_contact - SNMP contact as shown in the SNMP MIB. (.1.3.6.1.2.1.1.4.0).
v snmp_trap_community - community used for SNMP traps sent by the system.
v support_center_port_type -
v system_id - Unique system identifier (equivalent to a serial number).
v system_name -
Example:
Chapter 9. System Management 137
To Next Page
Loading...
Need help?
General
