User Category Permission
Security administrator Disallowed
Read-only users Disallowed
Technicians Disallowed
Completion Codes:
v LDAP_AUTHENTICATION_IS_ACTIVE
Command is not available while LDAP authentication is active
v USER_NAME_DOES_NOT_EXIST
User name does not exist
v USER_CANNOT_BE_DELETED
User cannot be deleted
v USER_IS_REFERRED_TO_BY_DEST
User is referred to by an event destination and therefore cannot be deleted
v USER_OWNS_RECOVERY_KEY
User owns recovery key and therefore cannot be deleted or renamed
Adding Users to a User Groups
Adds a user to a user group.
user_group_add_user user_group=UserGroup user=UserName
Parameters:
Name Type Description Mandatory
user_group Object name User group into which
the user is to be added.
Y
user Object name User to be added to the
user group.
Y
This command adds a user to a user group.
A user group can contain up to eight users.
A user may belong to only one user group.
Only users defined as Application Administrators can be assigned to a group.
This command fails when the user already belongs to the user group.
Example:
user_group_add_user user_group=ug1 user=user1
Output:
Command executed successfully.
380 IBM XIV Storage System User Manual
To Next Page
Loading...
