IBM XIV User Manual

Start UPS calibration
Example:
xcli -u -c XIV1 ups_start_calibration ups
Access Control:
User Category Permission
Storage administrator Disallowed
Storage integration administrator Disallowed
Application administrator Disallowed
Security administrator Disallowed
Read-only users Disallowed
Technicians Allowed
Completion Codes:
v UPS_IS_UNMONITORED
The specified UPS is not monitored and commands cannot be run on it
Troubleshooting: Contact support
v COMPONENT_DOES_NOT_EXIST
Component does not exist
v UPS_ALREADY_IN_CALIBRATION
UPS calibration is already pending or in progress
Troubleshooting: Contact support
v FIRMWARE_UPGRADE_IN_PROGRESS
Firmware upgrade in progress
Troubleshooting: Contact support
Start UPS Self Test
Start UPS self test
ups_start_self_test ups=ComponentId
Parameters:
Name Description Mandatory
ups The UPS to test Y
Start UPS self test
Example:
xcli -u -c XIV1 ups_start_self_test ups
Output:
Chapter 20. Hardware Maintenance 459

IBM XIV Specifications

General

Power Supply	Redundant power supplies
Drive Type	SATA
Redundancy	Fully redundant components
Connectivity	Fibre Channel, iSCSI
Form Factor	Rack-mounted
Cache	Distributed cache across modules
Data Protection	Snapshots, remote mirroring
Performance	High throughput and low latency
Scalability	Modular, scale-out architecture
Cooling	Redundant cooling
Architecture	Grid-based, distributed architecture