Completion Codes:
v FIRMWARE_UPGRADE_IN_PROGRESS
Firmware upgrade in progress
Troubleshooting: Contact support
v FIRMWARE_UPGRADE_UPS_CALIBRATING
Firmware upgrade cannot start while a UPS is calibrating
v MODULE_IS_NOT_OK
Module status is not OK
v FIRMWARE_UPGRADE_INVALID_LABEL
Firmware upgrade label invalid
v FIRMWARE_UPGRADE_NO_MATCHING_COMPONENTS
Firmware upgrade did not find any matching components
v FIRMWARE_UPGRADE_REQUIRES_ON_STATE
Firmware upgrade only allowed in ON state
v FIRMWARE_UPGRADE_INVALID_SCOPE
Firmware upgrade scope invalid
v FIRMWARE_UPGRADE_UNSUPPORTED_FIRMWARE_TYPE
Firmware upgrade not supported for this firmware type
v FIRMWARE_UPGRADE_NOT_ALL_COMPONENTS_OK
Firmware upgrade requires all components to be OK
v COMPONENT_DOES_NOT_EXIST
Component does not exist
Aborting a Firmware Upgrade
Aborts ongoing firmware upgrade of components
component_firmware_upgrade_abort
Aborts an ongoing firmware upgrade process. The abort is not synchronous, that
is, a currently upgrading component is allowed to finish its upgrade in order to
reach a consistent state.
Example:
xcli -u -c XIV1 component_firmware_upgrade_abort
Output:
Command completed successfully.
Access Control:
User Category Permission
Storage administrator Disallowed
Storage integration administrator Disallowed
Application administrator Disallowed
Security administrator Disallowed
Chapter 20. Hardware Maintenance
417
To Next Page
Loading...
