IBM XIV User Manual

Chapter 4. LUN Mapping Management
All the LUN mapping commands are obsolete and were replaced by the clustering
commands.
The following commands are no longer in use:
v map_add_vol (The concept of mapping has been replaced by clusters. See
map_volume.)
v map_create (The concept of mapping has been replaced by clusters. See
map_volume and cluster_create.)
v map_delete (The concept of mapping has been replaced by clusters. See
map_volume.)
v map_duplicate (The concept of mapping has been replaced by clusters.)
v map_link_host (The concept of mapping has been replaced by clusters. See
map_volume.)
v map_list (The concept of mapping has been replaced by clusters.)
v map_list_luns (The concept of mapping has been replaced by clusters. See
mapping_list)
v map_remove_vol (The concept of mapping has been replaced by clusters. See
unmap_volume.)
v map_rename (The concept of mapping has been replaced by clusters.)
v map_set_special_type (The concept of mapping has been replaced by clusters.
See special_type_set.)
v map_unlink_host (The concept of mapping has been replaced by clusters.)
61

IBM XIV Specifications

General

Power Supply	Redundant power supplies
Drive Type	SATA
Redundancy	Fully redundant components
Connectivity	Fibre Channel, iSCSI
Form Factor	Rack-mounted
Cache	Distributed cache across modules
Data Protection	Snapshots, remote mirroring
Performance	High throughput and low latency
Scalability	Modular, scale-out architecture
Cooling	Redundant cooling
Architecture	Grid-based, distributed architecture