User Category Permission
Security administrator Disallowed
Read-only users Disallowed
Technicians Disallowed
Enabling or Disabling LDAP-Based Authentication Mode
Enables/disables LDAP-based authentication mode.
ldap_mode_set mode=Mode
Parameters:
Name Type Description Mandatory
mode Boolean Required state of LDAP
authentication. Available
values: Active, Inactive.
Y
This command enables, or disables, LDAP-based authentication.
Example:
ldap_mode_set mode=active
Output:
Command executed successfully.
Access Control:
User Category Permission
Storage administrator Allowed
Storage integration administrator Disallowed
Application administrator Disallowed
Security administrator Disallowed
Read-only users Disallowed
Technicians Disallowed
Warnings:
v ARE_YOU_SURE_YOU_WANT_TO_ENABLE_LDAP_AUTHENTICATION
Are you sure you want to enable LDAP authentication?
v ARE_YOU_SURE_YOU_WANT_TO_DISABLE_LDAP_AUTHENTICATION
Are you sure you want to disable LDAP authentication?
Completion Codes:
v LDAP_IS_NOT_FULLY_CONFIGURED
LDAP is not fully configured
Troubleshooting: Check your settings.
v NO_LDAP_SERVERS_WITH_CERTIFICATE_ARE_DEFINED
Chapter 18. Access Control 373
To Next Page
Loading...
