Chapter 10. Remote Target Connectivity
The following sections describe the XIV Command Line Interface (XCLI) for
defining remote target connectivity.
The sections are listed as follows:
v target_change_connection_threshold(Setting a threshold for link disruption that
lasts more than a specified duration)
v target_config_sync_rates(Changes the target's mirroring configuration.)
v target_connectivity_activate(Activates connectivity between a port on the local
storage system and a port on a remote target.)
v target_connectivity_deactivate(Deactivates connectivity between a port on the
local storage system and a port on a remote target.)
v target_connectivity_define(Defines connectivity between a port on the local
storage system and a port on a remote target.)
v target_connectivity_delete(Deletes connectivity between a port on the local
storage system and a port on a remote target.)
v target_connectivity_list(Lists all the connectivity definitions of a remote target.)
v target_define(Defines a new remote target for remote mirroring or data
migration.)
v target_delete(Deletes the definition of a specified remote target.)
v target_list(Lists a specified remote target definition, or all the target definitions.)
v target_mirroring_allow(Allows remote mirroring operations initiated from the
remote target.)
v target_port_activate(Activates a port of a remote target.)
v target_port_add(Adds a port to a remote target.)
v target_port_deactivate(Deactivates a port of a remote target.)
v target_port_delete(Deletes a port from a specified remote target.)
v target_port_list(List all ports of a target.)
v target_rename(Renames a remote target.)
v target_update(Updates the target's configuration.)
The following commands are no longer in use:
v target_connectivity_test (Connectivity is reported in the target_connectivity_list
command.)
v target_portset_create (Port Sets are no longer in use in this version. Ports are
associated directly with targets.)
v target_portset_rename (Port Sets are no longer in use in this version. Ports are
associated directly with targets.)
v target_portset_delete (Port Sets are no longer in use in this version. Ports are
associated directly with targets.)
v target_portset_port_add (Port sets are no longer used. Use target_port_add
instead.)
v target_portset_port_delete (Port sets are not in use. Use target_port_delete.)
v target_portset_port_activate (Port sets are not in use any more. Use
target_port_activate instead.)
175
To Next Page
Loading...
