IBM XIV - Setting Configuration Parameters

config_get
Output:
Name Value
------------------------ -----------------------------------
email_sender_address support@ibm.com
email_reply_to_address storage@ibm.com
dns_primary 10.0.0.10
dns_secondary
iscsi_name iqn.2005-10.com.xivstorage:010140
system_name IBM Storage System
Access Control:
User Category Permission
Storage administrator Allowed
Storage integration administrator Allowed
Application administrator Allowed
Security administrator Allowed
Read-only users Allowed
Technicians Allowed
Completion Codes:
v UNRECOGNIZED_CONFIG_PARAMETER
Unrecognized configuration parameter: 'argument'.
Troubleshooting: Use a valid configuration parameter as an input.
Setting Configuration Parameters
Sets configuration parameters.
config_set name=Name value=ParamValue
Parameters:
Name Type Description Mandatory
name String Name of the parameter
to set.
Y
value String Value of the parameter. Y
This command sets the values of configuration parameters.
The values of the following parameters can be set:
v dns_master - IP address of the master DNS server.
v dns_slave - IP address of the slave DNS server.
v email_sender_address - Email address used as the sender's address when sending
email messages. Once set, this parameter can not be set to a null value.
v email_reply_to_address - Reply-to address to be used when sending emails. This
is useful for troubleshooting errors in email addresses.
138 IBM XIV Storage System User Manual