Access Control:
User Category Permission
Storage administrator Allowed
Storage integration administrator Allowed
Application administrator Disallowed
Security administrator Disallowed
Read-only users Disallowed
Technicians Disallowed
Completion Codes:
v VOLUME_BAD_NAME
Volume name does not exist
v COMMAND_NOT_SUPPORTED_FOR_OLVM_SOURCE_IN_THIS_STATE
The source is in an unsupported IBM Hyper-Scale Mobility state
v MIRROR_CONFIGURATION_ERROR
Mirror local configuration does not match remote configuration
v MIRROR_CONS_GROUP_MEMBERSHIP_MISMATCH
Mirrored CG contains different volumes on Master and Slave. This problem
occurs whenever the cg_add_vol or cg_remove_vol commands were previously
issued and the Master did not receive an acknowledgment from the Slave until
the command timed out, or any other unexpected failure.
v MIRROR_RETRY_OPERATION
There is an operation in progress on this mirror , please retry your request in a
few seconds
Troubleshooting: Please retry the command in a few seconds
v COMMAND_NOT_SUPPORTED_FOR_OLVM_DESTINATION_IN_THIS_STATE
The destination is in an unsupported IBM Hyper-Scale Mobility state
v MIRROR_SIZE_MISMATCH
Slave volume and Master Volume sizes are different
v REMOTE_VOLUME_IS_MASTER
Volume on remote machine is currently defined as Master
v REMOTE_MAX_VOLUMES_REACHED
Maximum number of volumes already defined on remote machine
v VOLUME_NOT_DEFINED_FOR_OLVM
The volume does not have IBM Hyper-Scale Mobility definitions
v OLVM_ALREADY_ACTIVE
The IBM Hyper-Scale Mobility relatino is already active.
v MAX_VOLUMES_REACHED
Maximum number of volumes already defined
Deactivates IBM Hyper-Scale Mobility Migration
Deactivates the migration of an IBM Hyper-Scale Mobility volume.
olvm_deactivate vol=VolName
Chapter 13. IBM Hyper-Scale Mobility
251
To Next Page
Loading...
