IBM XIV User Manual

Parameters:
Name Type Description Mandatory
ipinterfac
e
Object name IP interface to which the
port is to be added.
Y
port Integer Number of the port to
be added to the group.
Y
This command adds an Ethernet port to the link aggregation group of an IP
interface.
The specified port is added to the link aggregation group of the specified IP
interface.
Ports defined as a link aggregation group must be connected to the same Ethernet
switch, and a parallel link aggregation group must be defined on that Ethernet
switch.
The module is not provided, as it must be the module of the other ports of the
interface.
This command cannot be applied to Management or VPN interfaces.
Access Control:
User Category Permission
Storage administrator Allowed
Storage integration administrator Disallowed
Application administrator Disallowed
Security administrator Disallowed
Read-only users Disallowed
Technicians Allowed
Completion Codes:
v IPINTERFACE_DOES_NOT_EXIST
IP Interface name does not exist
v ILLEGAL_PORT_NUMBER
Port number is out of range
v PORT_ALREADY_IN_INTERFACE
Port is already part of the specified IP Interface
v PORT_IS_USED_IN_ANOTHER_IP_INTERFACE
One of the physical ports specified is already assigned to an IP Interface
v COMMAND_NOT_ALLOWED_ON_MANAGEMENT_INTERFACE
Operation is not allowed on Management IP Interface
v IPINTERFACE_NOT_AGGREGATED
Ports cannot be added to a non-aggregated IP Interface
312 IBM XIV Storage System User Manual

IBM XIV Specifications

General

Power Supply	Redundant power supplies
Drive Type	SATA
Redundancy	Fully redundant components
Connectivity	Fibre Channel, iSCSI
Form Factor	Rack-mounted
Cache	Distributed cache across modules
Data Protection	Snapshots, remote mirroring
Performance	High throughput and low latency
Scalability	Modular, scale-out architecture
Cooling	Redundant cooling
Architecture	Grid-based, distributed architecture