Ports defined as a link aggregation must be connected to the same Ethernet switch,
and the parallel link aggregation must be defined on that switch.
Access Control:
User Category Permission
Storage administrator Allowed
Storage integration administrator Disallowed
Application administrator Disallowed
Security administrator Disallowed
Read-only users Disallowed
Technicians Allowed
Completion Codes:
v IPINTERFACE_EXISTS
IP Interface name already used
v ILLEGAL_PORT_NUMBER
Port number is out of range
v PORT_IS_USED_IN_ANOTHER_IP_INTERFACE
One of the physical ports specified is already assigned to an IP Interface
v PORT_REPEATS_TWICE
Port list contains the same value more than once
v FORCE_NO_AGGREGATION_ALLOWED_FOR_SINGLE_PORT_ONLY
More than one port specified for non-aggregated IP Interface
v IP_ADDRESS_ALREADY_USED_IN_ANOTHER_INTERFACE
IP address is already assigned to another interface
v IPADDRESS_AND_GATEWAY_ARE_NOT_ON_SAME_SUBNET
IP address specified for the default gateway is not in the subnet of the IP
Interface
v MTU_TOO_LARGE
Specified MTU value is too large
v BAD_PORTS_FORMAT
Port list should be a comma separated list of positive integers
v ILLEGAL_COMPONENT_ID
Component ID is illegal
v TOO_MANY_PORTS_IN_AGGREGATION_GROUP
Too many physical ports for one IP interface
v ILLEGAL_IPADDRESS
Illegal IP address was entered
v DUPLICATE_IPADDRESSES
Duplicate IP addresses were specified
v ILLEGAL_GATEWAY_IPADDRESS
Illegal IP address was specified for default gateway
314 IBM XIV Storage System User Manual
To Next Page
Loading...
Need help?
General
