IBM XIV - Stopping System Traces; Resuming System Traces

Parameters:
Name Description Mandatory Default
ups Lists the status only for
the specified UPS.
N All UPS systems.
This command lists the status of the components of UPSs. The following
information is provided:
v Generic status
v Input power on: Y/N
v Battery charge level
v Last date of self-test
v Result of last self-test
v Is monitoring enabled
v Last calibration date
v result of last calibration
v Status of UPS
v Date of next self test
v Serial Number
v Load level percent
v Apparent load level percent
v Cable check result
Additional information, available through running ups_list -f all, includes:
v Last Calibration Date
v Last Calibration Result
v Next Self Test
v Serial
v Original Serial
v Load % Watts
v Apparent Load % VA
v Minutes Left
v Temperature
v AOS Version
v Self-test Status
v Component Test Status
v Batteries Date
v UPS Manufacture Date
v Cable check result
Id Name Default Position
component_id Component ID 1
status Status 2
currently_
functioning
Currently Functioning 3
input_power_on Input Power On 4
442 IBM XIV Storage System User Manual