Keysight 53230A - Page 200

*TRG
Syntax
*TRG
Description
This command is used in conjunction with the TRIGger:SOURce command to trigger the instrument from
the remote interface.
Remarks
l Use the TRIGger:SOURce command to select the BUS (software) trigger source.
l After setting the trigger source, you must place the instrument in the "wait-for-trigger" state using the
INITiate command. The *TRG command will not be accepted unless the instrument is in the "wait-for-
trigger" state.
Examples
The following example triggers the instrument.
TRIG:SOUR BUS
INIT
*TRG
See Also
TRIGger:SOURce
*TRG
200 Keysight 53220A/53230A Programmer's Reference