Keysight 53230A - Page 492

Channels 1 & 2:
Coupling AC
Low-pass Filter OFF
Impedance 1 Mohm
Level (absolute) 0.0
Level (relative) 50
Auto-level Enabled
Noise rejection Disabled
Range 5 V
Slope POSitive
Channel 3:
Level -6 dB
Output Configuration
Default/Factory Setting
Output enable OFF
Output polarity POSitive
Trigger/Sample Configuration
Default/Factory Setting
Trigger Count 1
Trigger Source Immediate
Trigger Slope NEGative
Trigger Delay 0.0
Sample Count 1
Calculate Operations
Default/Factory Setting
Calculate State Disabled
Smoothing State Disabled
Smoothing Response FAST
Scaling State Disabled
Gain factor 1.0
Offset 0.0
Limit testing State Disabled
Lower limit 0.0
Upper limit 0.0
Statistics State Disabled
Histogram State Disabled
Number of Bins 100
Automatic Range Value Selection Enabled
Power-On and Reset State
492 Keysight 53220A/53230A Programmer's Reference