Krone Big Pack 890 XC - Page 538

9 Terminal – menus [Medium Plus/Comfort Plus Electronics]
9.16 Alarm messages
94
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
Error number Possible cause Remedy
522060-7 The packer is blocked. • Stop the travelling gear
immediately.
• Reduce the PTO speed until the
crop blockage has been
removed.
• Set the sensor.
522061-7
OFF
Timeout for locking/releasing the self-
steering axle
• Check the hydraulic connection.
• Check the sensor and replace if
required.
522062-7 The pick-up is blocked. • Check the mechanism.
• Remove the crop blockage.
522063-1 The pick-up speed is below the
minimum speed.
• Set the sensor.
522064-7 The pick-up has not been raised in
road mode.
• Raise the pick-up.
522065-7 The pick-up is not detected in road
mode.
• Raise the pick-up.
522066-7 The twine boxes were moved from
the locked position without request.
• Raise the twine boxes.
522067-7 The twine boxes are not in the locked
position and the cardan shaft is
active.
522068-7 The twine boxes are not in the locked
position when the machine starts.
522069-1
B57
The minimum speed for knotter
cleaning was not reached.
• Increase the speed.
522071-7
S3
The "Move in residual bale ejector"
pushbutton is sticking.
• Eliminate the cause of the
pushbutton sticking.
• Replace the pushbutton.
522072-7
S4
The "Move out residual bale ejector"
pushbutton is sticking.
522073-12 Automatic mode is not possible
because the bale chute at top has
been lowered.
• Lower the bale chute.