Settings
187
Pos: 50.5.39 /B A/Einstellungen/R undballenpre sse/Netz- und F olienbindung Ei nstellungen/ Bindematerialbre mse einstellen_ Verriegelungsb olzen_text_Netz - und Folien bindung_ALL E Comprima @ 5 12\mod_1502 891704094_7 8.docx @ 35086 40 @ @ 1
Setting (I) (net wrapping): The locking pin with ball head (3) is released (shown with a red
border in the picture). The clamping lever (2) lies against the net roll (1).
Position (II) (chamber film wrapping): The locking pin with ball head (3) is locked in the side
wall (shown with a red border in the picture). This keeps the clamping lever (2) in bottom
position so that it does not touch the film roll (1).
Changing the chamber film wrapping from position (I) to position (II)
• To lock the locking pin with ball head (3), turn the ball head clockwise until the roll pin (4)
passes through the slit.
• At the same time, move the clamping lever (2) down to the borehole.
The compression spring automatically presses the bolt into the borehole.
Changing the net wrapping from position (II) to position (I)
• To release the locking pin with ball head (3), turn the ball head counter-clockwise and pull
the bolt in the direction of the arrow until the roll pin (4) passes through the slit and the bolt
has snapped home.
Pos: 50.5.40 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
