Settings
191
Pos: 50.5.55 /B eipacks/Rundb allenpressen/Foli enbindung/Mo dulgruppen U mbau 2015/Beschr eibung 3: Rüc khaltekamm montieren @ 51 5\mod_15045 10798200_78.d ocx @ 3537008 @ @ 1
Position I
The trapezoidal rubbers (4) at the underside of the retaining comb are pre-assembled with the
short side pointing backward, seen in direction of travel. The picture shows the underside of the
retaining comb.
Position II
If the blue strips (1) are picked up by the first net roller with a delay or not at all, you can reverse
the trapezoidal rubbers (4). This provides for additional support.
Carry out the following setting at all 6 trapezoidal rubbers (4):
• Dismount the screw connections (3) and the metal strip (2).
• Turn the trapezoidal rubber (4) 180° so that the shorter end points in the direction of travel
(position II).
• Make sure that the brown fabric side is facing down.
• Mount the metal strip (2) with the screw connections (3).
• Make sure that the borehole (5) on the metal strip (2) is facing against the direction of travel.
Pos: 50.5.56 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
