7: Networking
EMG™ Edge Management Gateway User Guide 109
4. To save, select Apply.
Active Client List
This table shows the list of clients currently connected to the access point. Click on a MAC
Address to view more information about the client.
Interface Counters
This table shows statistics for data received by and transferred from the access point.
Encryption When the Security Suite is set to WPA or WPA2, this selects the
encryption used: CCMP for AES in Counter mode with CBC-MAC
(preferred), TKIP for Temporal Key Integrity Protocol, or Any for both
CCMP and TKIP.
Passphrase/Retype Passphrase If WPA or WPA2 is selected for the Security Suite, enter the password
to connect to the access point.
IP Address Specifies the IP address of the access point.
Subnet Mask Specifies the network segment of the access point.
DHCP Pool Start/End IP
Address
The access point provides DHCP addresses to clients that connect to
the access point. The DHCP Pool specifies the starting and ending IP
address of the addresses (maximum of 5 clients can connect to the
access point). These addresses must be in the same subnet as the IP
address of the access point.
To Next Page
Loading...
Need help?
General
