Lantronix EMG Series User Manual

17: Command Reference
EMG™ Edge Management Gateway User Guide 457
set wlan profile wpapsk <Profile Name>
set wlan profile wpa802password <Profile Name>
Enable a default profile that allows network scanning without a custom profile:
set wlan profile defaultprofile <enable|disable>
Configure the wireless client interface:
set wlan interface <parameters>
Parameters
state <dhcp|static> [ipaddr <IP Address> mask <Mask>]
ipv6addr <IPv6 Address/Prefix>
mtu <Maximum Transmission Unit>
Set the WiFi radio's regulatory domain. The supported regions are FCC
(United States), IC (Industry Canada), CN (China), JP (Japan), KCC (Korea),
ETSI (Europe without EN 300 440 support), EN440 (Europe with EN 300 440
support), AU (Australia) and WW (World Mode):
set wlan radio region <ww|fcc|ic|etsi|en440|kcc|jp|cn|au>
Warning: Each time the region is changed it is programmed into the radio,
which can be done a maximum of ~10 times; use care when changing the region.
show wlan [email <Email Address>]
show wlan accesspoint [display <clients|detailed|all>]
[email <Email Address>]
show wlan interface [email <Email Address>]
show wlan networks [display <list|detailed>] [email <Email Address>]
show wlan profiles [display <list|detailed>] [email <Email Address>]
[profile <Profile Name>] [viewkeys <enable|disable>]
show wlan radio [email <Email Address>]
Note: see 'diag wlan' for diagnostic tools.
Temperature Commands
set temperature
Syntax
set temperature

Lantronix EMG Series Specifications

General

Brand	Lantronix
Model	EMG Series
Category	Gateway
Language	English