EMG™ Edge Management Gateway User Guide 461
Appendix B: Safety Information
Safety Precautions
Please follow the safety precautions described below when installing and operating the EMG.
Caution: EQUIPMENT IS FOR INDOOR USE ONLY!
Cover
Do not remove the cover of the chassis. There are no user-serviceable parts inside. Opening
or removing the cover may expose you to dangerous voltage that could cause fire or electric
shock.
Refer all servicing to Lantronix.
Power Plug
Connect the power plug in the following order: 1) Connect the DC plug to the EMG first. 2)
Connect the AC cable to the external power supply. 3) Connect the AC cable to the power
source. When removing power, the AC cable to the power source should be unplugged first.
Always connect the power cord to a properly wired and grounded power source. Do not use
adapter plugs or remove the grounding prong from the cord.
When disconnecting the power cable from the socket, pull on the plug, not the cord.
Only use a power cord with a voltage and current rating greater than the voltage and current
rating marked on the EMG unit.
The EMG unit must be connected to a branch circuit provided with 15A or 20A, single pole
circuit breaker.
Install the EMG near an AC outlet that is easily accessible.
Always connect any equipment used with the product to properly wired and grounded power
sources.
To help protect the product from sudden, transient increases and decreases in electrical
power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).
Do not connect or disconnect this product during an electrical storm.
To Next Page
Loading...
Need help?
General
