7: Networking
EMG™ Edge Management Gateway User Guide 139
Performance Monitoring - Add/Edit Probe
The Performance Monitoring - Add/Edit Probe web page allows a user to add a new Performance
Monitoring probe or edit an existing Performance Monitoring probe.
To add a new probe or edit an existing probe:
1. Click the Network tab and select the Perf Monitoring option. The Network > Perf Monitoring
page displays.
2. To add a new probe, in the lower section of the page, select the Add Probe link. To edit an
existing probe, select a probe by clicking the radio button to the right in the probe's row, then
select the Edit Probe button. In both cases, the following page displays.
Figure 7-15 Performance Monitoring - Add/Edit Probe
To Next Page
Loading...
Need help?
General
