EMG™ Edge Management Gateway User Guide 79
7: Networking
This chapter explains how to set the following network settings for the EMG using the web
interface or the CLI:
Network Port Settings
Cellular Modem Settings
Wireless Settings
IP Filter and Routing
VPN Settings
Security
Performance Monitoring
FQDN List
Requirements
If you assign a different IP address from the current one, it must be within a valid range and unique
to your network. If a valid gateway address has not been assigned the IP address must be on the
same subnet as workstations connecting to the EMG over the network.
To configure the unit, you need the following information:
Eth1 IP address: ________ - ________ - ________ - ________
Subnet mask: ________ - ________ - ________ - ________
Eth2 IP address (optional): ________ - ________ - ________ - ________
Subnet mask (optional): ________ - ________ - ________ - ________
Gateway: ___________ - ___________ - ___________ - ___________
DNS: ___________ - ___________ - ___________ - ___________
To Next Page
Loading...
