15: Maintenance
EMG™ Edge Management Gateway User Guide 354
Events
On this Maintenance > Events page, you can define what action you want to take for events that
may occur in the EMG unit.
1. Click the Maintenance tab and select the Events option. The following page displays:
Figure 15-13 Maintenance > Events
2. Enter the following:
Event Trigger From the drop-down list, select the type of incident that triggers an event. Currently,
the options are:
Receive Trap
Temperature Over/Under Limit (for Sensorsoft devices)
Humidity Over/Under Limit (for Sensorsoft devices)
Device Port Data Drop
No Internal Modem Dial Tone
Ping Host Fails
RPM Load Over Threshold
DIO Port State Change
DIO Port State Abnormal
Host to Ping When the trigger is set to Ping Host Fails, enter the hostname, IPv4 address or
IPv6 address of the host to ping. The host will be pinged every 2 minutes.
RPM When the trigger is set to RPM Load over Threshold, select the RPM that will be
monitored for a current that exceeds a defined threshold. The RPM needs to
support providing a current level as part of its status information. The RPM current
will be checked every 2 minutes.
To Next Page
Loading...
Need help?
General
