Lantronix EMG Series User Manual

14: User Authentication
EMG™ Edge Management Gateway User Guide 314
Figure 14-9 User Authentication > TACACS+
2. Enter the following:
Enable TACACS+ Displays selected if you enabled this method on the User Authentication page. If
you want to set up this authentication method but not enable it immediately, clear
the checkbox.
You can enable TACACS+ here or on the first User Authentication page. If you
enable TACACS+ here, it automatically displays at the end of the order of
precedence on the User Authentication page.
TACACS+ Servers 1-3 IPv4 or IPv6 address or host name of up to three TACACS+ servers.
Secret/Retype Secret Shared secret for message encryption between the EMG and the TACACS+
server. Enter an alphanumeric secret of up to 127 characters.
Encrypt Messages Select the checkbox to encrypt messages between the EMG unit and the
TACACS+ server. Selected by default.

Lantronix EMG Series Specifications

General

Brand	Lantronix
Model	EMG Series
Category	Gateway
Language	English