17: Command Reference
EMG™ Edge Management Gateway User Guide 405
Device Commands
set command
Syntax
set command <Device Port # or Name or List> <one or more parameters>
Parameters
sensorsoft lowtemp <Low Temperature>
Sets the lowest temperature permitted for the port.
sensorsoft hightemp <High Temperature>
Sets the hightest temperature permitted for the port.
sensorsoft lowhumidity <Low Humidity %>
Sets the lowest humidity pemitted for the port.
sensorsoft highhumidity <High Humidity %>
Sets the lowest humidity permitted for the port.
sensorsoft degrees <celsius|fahrenheit>
Enables or disables temperature settings as celcius or fahrenheit.
sensorsoft traps <enable|disable>
Enables or disables traps when specified conditions are met.
sensorsoft status
Displays the status of the port.
sensorsoft showall
Displays the status for all connected Sensorsoft devices and ignores the device port\nlist.
Note: The Sensorsoft lowtemp and hightemp settings are given in the scale specified by
the degrees setting.
Description
Sends commands to (or control) a device connected to an EMG device port over the serial port.
Note: Currently the only devices supported for this type of interaction are Sensorsoft
devices.
To Next Page
Loading...
Need help?
General
