Lantronix EMG Series User Manual

14: User Authentication
EMG™ Edge Management Gateway User Guide 293
Figure 14-4 User Authentication > Local/Remote User Settings
2. Enter the following information for the user:
Login User ID of selected user.
Authentication Select the type of authenticated user:
 Local: User listed in the EMG database.
 Remote: User not listed in the EMG database.
UID A unique numeric identifier the system administrator assigns to each user.
Valid UIDs are 101-4294967295.
Note: The UID must be unique. If it is not, EMG unit automatically increments
it. Starting at 101, the EMG finds the next unused UID.
Listen Ports The device ports that the user may access to view data using the connect
listen command. Enter the port numbers or the range of port numbers (for
example, 1, 5, 8, 10-15). U1 denotes the USB port on the EMG unit.
Data Ports The device ports with which the user may interact using the connect direct
command. Enter the port numbers or the range of port numbers.
Clear Port Buffers
The device port buffers the users may clear using the
set locallog
clear
command. Enter the port numbers or the range of port numbers.

Lantronix EMG Series Specifications

General

Brand	Lantronix
Model	EMG Series
Category	Gateway
Language	English