8: Services
EMG™ Edge Management Gateway User Guide 165
2. Enter the following:
3. To save, click the Apply button.
To synchronize the EMG with a remote timeserver using NTP:
1. Enter the following:
2. To save, click the Apply button.
Date and Time Commands
Go to Date and Time Commands (on page 403) to view CLI commands which correspond to the
web page entries described above.
Change Date/Time
Select the checkbox to manually enter the date and time at the
EMG location.
Date From the drop-down lists, select the current month, day, and year.
Time From the drop-down lists, select the current hour and minute.
Time Zone From the drop-down list, select the appropriate time zone. For information on each
timezone, see http://en.wikipedia.org/wiki/List_of_tz_database_time_zones
Enable NTP Select the checkbox to enable NTP synchronization. NTP is disabled by default.
Current NTP status Displays the current NTP status if NTP is enabled above.
Synchronize via Select one of the following:
Broadcast from NTP Server: Enables the EMG unit to accept time
information periodically transmitted by the NTP server. This is the default if
you enable NTP.
Poll NTP Server: Enables the EMG to query the NTP Server for the correct
time. If you select this option, complete one of the following:
Local: Select this option if the NTP servers are on a local network, and
enter the IPv4 or IPv6 address of up to three NTP servers. This is the
default, and it is highly recommended.
Public: Select this option if you want to use a public NTP server, and select
the address of the NTP server from the drop-down list. This is not
recommended because of the high load on many public NTP servers. All
servers in the drop-down list are stratum-2 servers. (See www.ntp.org
for
more information.) Each public NTP server has its own usage rules --please
refer to the appropriate web site before using one. Our listing them here is
to provide easy configuration but does not indicate any permission for use.
To Next Page
Loading...
Need help?
General
