EMG™ Edge Management Gateway User Guide 4
Revision History
Date Rev. Comments
October 2019 A Initial release for EMG 8500
February 2020 B
Updated the compliance section.
Added information about device-unique local default password for devices
manufactured after January 1, 2020 and installed with firmware version 8.2.0.1
or greater.
April 2020 C This document describes the EMG firmware release 8.3.0.0. It contains the initial
release for EMG 7500 and includes the following software changes:
Added Wi-Fi support, both WLAN client mode and access point mode.
Upgraded FIPS support with latest security algorithms and added support for
VPN, SNMP, and Web SSH added in FIPS mode.
Expanded Zero Touch Provisioning (ZTP) to support more methods of
downloading a configuration to apply to a factory default EMG.
Added internal analog modem support, including alternate network path
support, with fail-over and fail-back.
Note: EMG 8500 firmware cannot be installed on EMG 7500, and vice versa.
To Next Page
Loading...
Need help?
General
