5: Quick Setup
EMG™ Edge Management Gateway User Guide 70
After you complete the Quick Setup script, the changes take effect immediately.
Figure 5-6 Quick Setup Completed in CLI
Welcome to the Lantronix Edge Management Gateway
Model Number: EMG851000
Quick Setup will now step you through configuring a few basic settings.
The current settings are shown in brackets ('[]').
You can accept the current setting for each question by pressing
<return>.
____Ethernet Port and Default Gateway___________________________________
The EMG851000 has two ethernet ports, Eth1 and Eth2.
By default, both ports are configured for DHCP.
Configure Eth1: (1) obtain IP Address from DHCP
(2) obtain IP Address from BOOTP
(3) static IP Address
Enter 1-3: [1]
The EMG851000 can be configured to use a default gateway.
Enter gateway IP Address: [none]
____Hostname____________________________________________________________
The current hostname is 'emgfcf0', and the current domain is
'<undefined>'.
The hostname will be shown in the CLI prompt.
Specify a hostname: [emgfcf0]
Specify a domain: [<undefined>]
____Time Zone___________________________________________________________
The current time zone is 'GMT'.
Enter time zone: [GMT]
____Date/Time___________________________________________________________
The current time is Wed Jul 3 14:23:24 2019
Change the current time? [n]
____Sysadmin Password___________________________________________________
Enter new password: [<current password>]
Quick Setup is now complete.
Date/Time If the date and time displayed are correct, type n and continue. If the date and time
are incorrect, type y and enter the correct date and time in the formats shown at the
prompts.
Sysadmin
password
Enter a new sysadmin password.
Note: As a security measure, we recommend that you change the default sysadmin
password initially and then change the password periodically.
CLI Quick Setup
Settings
Description
To Next Page
Loading...
Need help?
General
