Lantronix EMG Series

6: Web and Command Line Interfaces
EMG™ Edge Management Gateway User Guide 74
- Select a port and the WebSSH option: displays the WebSSH window for the device port -
if Web SSH is enabled, and if SSH is enabled for the device port.
.
- Select a port and the Connected Device option: allows access to supported devices such
as remote power managers (RPMs) and/or SensorSoft temperature and humidity probes
connected to the device port.
 Entry Fields and Options: Allow you to enter data and select options for the settings.
Note: For specific instructions on completing the fields on the web pages, see Chapters
6 through 14.
 Apply Button: The Apply button (not shown in Figure 6-1 Web Page Layout) on each web
page makes the changes immediately and saves them so they will be there when the EMG is
rebooted.
 Icons: The icon bar above the Main Menu has icons that display the following:
Home page.
Information about the EMG unit and Lantronix contact information.
Configuration site map.
Status of the EMG.
 Help Button: Provides online Help for the specific web page.
Logging in
Only the system administrator or users with web access rights can log into the Web Manager.
More than one user at a time can log in, but the same user cannot log in more than once.
To log in to the Web Manager:
1. Open a web browser.
2. In the URL field, type https:// followed by the IP address of your EMG.
3. To configure the EMG unit, use sysadmin as the user name and the last 8 characters of the
Device ID (for newly manufactured units that come installed with 8.2.0.1 or later) or PASS (for
all older units) as the password. (These are the default values.)
Note: If the Device ID is not set, the default system password is the last 8 characters
of the serial number.
Note: The system administrator may have changed the password using one of the
Quick Setup methods in the previous chapter.
The Quick Setup page displays automatically the first time you log in. Subsequently, the Home
page displays. (If you want to display the Quick Setup page again, click Quick Setup on the main
menu.)
Logging Out
To log off the EMG web interface: