8: Services
EMG™ Edge Management Gateway User Guide 174
Figure 8-13 Services > ConsoleFlow
2. Enter the following:
ConsoleFlow Client Enables or disables the ConsoleFlow client. This option is enabled by default,
unless an EMG is not configured with a Device ID. When the client is enabled, it
will attempt to register with the Registration Host. If this is successful, the
client will attempt to establish a connection with the Messaging Host. The
General log (see SSH/Telnet/Logging on page 147) will contain messages
about connections made to the Registration Host and Messaging Host. Status
of Client displays the last time of actions performed by the client. Note that
when the client is disabled, it may take as long as 30 seconds for the client to
terminate, depending on what actions the client was performing at the time it
was disabled.
Interval between status
updates
Number of minutes between status updates sent from the client to the server.
Valid values are 1 - 60 minutes. The default is 2 minutes.
To Next Page
Loading...
Need help?
General
