17: Command Reference
EMG™ Edge Management Gateway User Guide 442
sha2 <enable|disable> v3auth <md5|sha|sha2_224|sha2_256|
webssh <enable|disable> sha2_384|sha2_512>
smtpserver <IP Address or Name> v3encrypt <des|aes>
smtpsender <Email Address> phonehome <enable|disable>
termbufsize <Number of Lines> phoneip <IP Address>
Description
Configures services (system logging, SSH and Telnet access, SSH and Telnet timeout, SNMP
agent, email [SMTP] server, and audit log.)
set services v3password
Syntax
set services v3password|v3phrase|v3rwpassword|v3rwphrase|v3trappassword
|v3trapphrase
Description
Set SNMP v3 read-only, read-write and trap password/passphrase.
show services
Syntax
show services
Description
Displays current service settings.
Site Commands
Configure a set of site-oriented modem parameters that can be activated by various modem-
related events (authentication, outbound network traffic for DOD connections, etc.). The site
parameters will override any parameters configured for the modem. To use sites with a modem,
enable 'usesites'. Sites can be used with the following modem states: dialin, dialback, cbcpserver,
dialondemand, dialin+ondemand, and dialback+ondemand.
set site add|edit
Syntax
set site add|edit <Site Name> [<parameters>]
Parameters
name <Site Name> (edit only)
deviceport
<Device Port # or Name or none>
dialoutnumber <Phone Number>
usbport <U1> dialoutlogin <User Login>
To Next Page
Loading...
Need help?
General
