Lantronix EMG Series

17: Command Reference
EMG™ Edge Management Gateway User Guide 434
Description
Delete a probe, or delete all operation data for a probe, or delete all but the most recent operation
sets for a probe.
set perfmon state
Syntax
set perfmon state <all|Probe Id or Name> action <restart>
Description
Set the running state of all probes or a single a probe.
Routing Commands
set routing
Syntax
set routing [parameters]
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names (enable).
You can optionally email the displayed information.