6: Web and Command Line Interfaces
EMG™ Edge Management Gateway User Guide 75
1. Click the Logout button located on the upper left part of any Web Manager page. You are
brought back to the login screen when logout is complete.
Web Page Help
To view detailed information about an EMG web page:
1. Click the Help button to the right of any Web Manager page. Online Help contents will appear
in a new browser window.
Command Line Interface
A command line interface (CLI) is available for entering all the commands you can use with the
EMG. In this user guide, after each section of instructions for using the web interface, you will find
a link to the equivalent CLI commands. You can access the command line interface using Telnet,
SSH, or a serial terminal connection.
Note: By default, Telnet is disabled and SSH is enabled. To enable Telnet, use the
Services > SSH/Telnet/Logging web page, a serial terminal connection, or an SSH
connection. (See Chapter 8: Services.)
The sysadmin user and users with full administrative rights have access to the complete command
set, while all other users have access to a reduced command set based on their permissions.
Logging In
To log in to the EMG command line interface:
1. Do one of the following:
- With a serial terminal connection, power up, and when the command line displays, press
Enter.
- If the EMG already has an IP address (assigned previously or assigned by DHCP), Telnet
(if Telnet has been enabled) or SSH to xx.xx.xx.xx (the IP address in dot quad
notation) and press Enter. The login prompt displays.
2. To log in as the system administrator for setup and configuration, enter sysadmin as the user
name and press Enter.
3. Enter the last 8 characters of the Device ID (for newly manufactured units that come installed
with 8.2.0.1 or later) or PASS as the password and press Enter. The first time you log in, the
Quick Setup script runs automatically. Normally, the command prompt displays. (To display
the Quick Setup script again, use the admin quicksetup command.)
Note: If the Device ID is not set, the default sysadmin password is the last 8
characters of the serial number.
Note: The system administrator may have changed the password using one of the
Quick Setup methods in the previous chapter.
To log in any other user:
1. Enter your EMG user name and press Enter.
To Next Page
Loading...
Need help?
General
