Lantronix EMG Series User Manual

15: Maintenance
EMG™ Edge Management Gateway User Guide 344
Audit Log
The Maintenance > Audit Log page displays a log of all actions that have changed the
configuration of the EMG. The audit log is disabled by default. Use the Services > SSH/Telnet/
Logging page (Chapter 8: Services) to enable the audit log and to configure its maximum size.
Each entry in the log file contains a date/time stamp, user login, and the action performed by the
user. The user may clear the log file and sort the log by date/time, user, and command. The audit
log is saved through EMG reboots.
1. Click the Maintenance tab and select the Audit Log option. The following page displays:
Figure 15-5 Maintenance > Audit Log
2. To select a sort option, click the appropriate button:
- To sort by date and time, click the sort by Date/Time button (this is the default.)
- To sort by user, click the sort by User button.
- To sort by command/action, click the sort by Command button.
3. To email this log, follow the instructions in Emailing Logs and Reports (on page 352).
4. To clear the log, click the Clear Log button.
5. To freeze or stop automatic refreshing of the log, click the Stop Refresh button.
Audit Log Commands
Go to Audit Log Commands to view CLI commands which correspond to the web page entries
described above.

Lantronix EMG Series Specifications

General

Brand	Lantronix
Model	EMG Series
Category	Gateway
Language	English