14: User Authentication
EMG™ Edge Management Gateway User Guide 289
User Rights
The EMG has three user groups: Administrators, Power Users, and Default Users. Each has a
predefined set of rights; users inherit rights from the user group to which they belong. These rights
are in addition to the current functions that a user can perform at the command line interface:
connect direct/listen
set locallog/password/history/cli
show datetime/deviceport/locallog/portstatus/portcounters/
history/cli/user
The table below shows the mapping of groups and user rights.
Table 14-2 User Types and Rights
You cannot deny a user rights defined for the group, but you can add or remove all other rights at
any time.
By default, the system assigns new users to the Default Users group, but you can change their
group membership at any time. If you change a user's rights while the user is logged into the web
or CLI, the results do not take effect until the next time the user logs in.
User Right Administrator Power Users Default Users
Full Administrative Rights
X
Networking
X X
Services
X
Date/Time
X X
Local Users
X
Remote Authentication
X
SSH Keys
X
User Menus
X
Device Port Operations
X
Device Port Configuration
X
USB
X
Reboot/Shutdown
X X
Firmware/Configuration
X
Diagnostics and Reports
X X
Secure Lantronix Network
X
Web Access
X X
Internal Modem
X
RPMs
X
SD Card
X
To Next Page
Loading...
Need help?
General
