Lantronix EMG Series

17: Command Reference
EMG™ Edge Management Gateway User Guide 433
packets <Number of Packets to Send>
interval <Milliseconds between Packets>
timeout <Milliseconds to Wait for Response>
host <Destination IP Address or Name>
port <Destination Port>
precision <milli|micro>
datasize <Payload Data Size in Bytes>
verifydata <enable|disable>
codec <g729a|g711alaw|g711mulaw>
tos <none|Type of Service>
interface <all|eth1|eth2|cell|wlan|ap>
nameserver <IPv4 Address>
Description
Add a new probe.
set perfmon edit
Syntax
set perfmon edit <Probe Id or Name> [<parameters>]
Parameters
name <Probe Name>
starttime <now|HH:MM[:SS][MMDD]|afterHH:MM:SS>
operations <Number of Operations to Perform>
frequency <Seconds between Operations>
packets <Number of Packets to Send>
interval <Milliseconds between Packets>
timeout <Milliseconds to Wait for Response>
host <Destination IP Address or Name>
port <Destination Port>
precision <milli|micro>
datasize <Payload Data Size in Bytes>
verifydata <enable|disable>
codec <g729a|g711alaw|g711mulaw>
tos <none|Type of Service>
interface <none|eth1|eth2>
nameserver <IPv4 Address>
Description
Edit an existing probe.
set perfmon delete
Syntax
set perfmon delete <Probe Id or Name> [data <all|# of Sets to Keep>]