Lantronix EMG Series

12: Scripts
EMG™ Edge Management Gateway User Guide 264
Batch Script—EMG CLI
This script runs the following EMG CLI commands, then runs the Monport Interface script:
 show network port 1 host
 show deviceport names
 show script
 connect script monport deviceport 7
The following is the screen output of the script:
[emg247]> se script runcli cli
[emg247]> show network port 1 host
___Current Hostname Settings____________________________________________
Hostname: emg247
Domain: <none>
[emg247]>
[emg247]> show deviceport names
___Current Device Port
Names____________________________________________
01 - SCS_ALIAS_Test 05 - Port-5
02 - Port-2 06 - Port-6
03 - Port-3 07 - EMG251
04 - Port-4 08 - Port-8
[emg247]>
[emg247]> show script
___Interface Scripts______Group/Permissions_____________________________
getSLC Adm/ad,nt,sv,dt,lu,ra,um,dp,pc,rp,rs,fc,dr,sn,wb,sk,po,do
Test Adm/ad,nt,sv,dt,lu,ra,um,dp,pc,rp,rs,fc,dr,sn,wb,sk,po,do
monport Adm/<none>
___Batch Scripts__________Group/Permissions_____________________________
cli Adm/ad,nt,sv,dt,lu,ra,um,dp,pc,rs,fc,dr,sn,wb,sk,po,do,rp
[emg247]>
[emg247]> connect script monport deviceport 7
login: Logging in....
sysadmin
sysadmin
Password: PASS
Welcome to the Lantronix Edge Management Gateway
Model Number: EMG851101
For a list of commands, type 'help'.
[EMG251]> show network port 1 host
show network port 1 host
___Current Hostname Settings____________________________________________
Hostname: EMG251
Domain: support.int.lantronix.com
Device HOSTNAME: EMG251
Monitored Port: Port 7
Monitor Interval Time: 5 Seconds
[Current Time:21:25:04]
show portcounter deviceport 7
[EMG251]> show portcounter deviceport 7