Lantronix EMG Series User Manual

17: Command Reference
EMG™ Edge Management Gateway User Guide 436
set rpm driver
Syntax
set rpm driver <RPM Id or Name> action restart
set rpm driver <RPM Id or Name> action debug [level <1|2|3>]
set rpm driver <RPM Id or Name> action show
set rpm driver <RPM Id or Name> action viewoutput [email <Email Address>]
[display <head|tail>] [numlines <Number of Lines>]
Description
Control and debug the RPM driver if the driver is not properly communicating with the PDU or
UPS: restart the driver; restart the driver with debug output to a file; show the running driver; view
and email the driver debug output.
Note: Drivers running in debug mode will generate copious output and for disk space
reasons should not be left running in debug mode for long periods of time.
set rpm edit
Syntax
set rpm edit <RPM Id or Name> <one or more parameters>
Parameters
name <New RPM Name>
outlets <# of Outlets>
ipaddr <IP Address>
port <TCP or Device Port>
login <RPM Admin Login>
rocommunity <SNMP Read-Only Community>
rwcommunity <SNMP Read-Write Community>
logstatus <disable|1-60 minutes>
snmptraps <enable|disable>
emailaddress <Email Address>
upslowbattery <shutdown|shutdownall|shutdownboth|allowfailure>
sdorder <disable|1-49>
powertoslc <enable|disable>
driveropts <Driver Options Override>
Description
Configure and control Remote Power Managers (RPMs), including PDUs and UPSes.
set rpm password
Syntax
set rpm password <RPM Id or Name>

Lantronix EMG Series Specifications

General

Brand	Lantronix
Model	EMG Series
Category	Gateway
Language	English