4 Reattach the envelope feeder.
5 Connect the power cord to a properly grounded outlet.
6 Restart the printer.
• Press to clear the message and print without using the envelope feeder.
Remote Management Active DO NOT POWER OFF
The printer settings are being configured. Wait for the message to clear.
Warning—Potential Damage: Do not turn the printer power
o
while Remote Management Active
appears on the display.
Remove packaging material, check <x>
Remove any remaining packaging material from the specified location.
Remove paper from all bins
Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from bin <x>
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes
printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from standard output bin
Remove the stack of paper from the standard exit bin.
Remove paper from <linked bin set name>
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes
printing.
If removing the paper does not clear the message, press
.
Replace wiper
Try one or more of the following:
• Replace the fuser wiper.
• Press the arrow buttons until Continue appears, and then press to clear the message and
continue printing.
4062
Diagnostic information
168
To Next Page
Loading...
