Sensor (media in stapler) static jam (staple finisher) service check
Action Yes No
Step 1
Check if the sensor (media in stapler) is properly installed. If
necessary, reinstall the sensor.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the sensor or damage. If necessary, replace the sensor. Go
to
“Sensor (SFP stapler assembly media in stapler) removal” on
page 448.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Understanding the printer messages
Activating Menu Changes
Wait for the message to clear.
Busy
Wait for the message to clear.
Cancel not available
Wait for the message to clear.
Canceling
Wait for the message to clear.
Change <src> to <x>
<src> is a tray or feeder, and <x> is a paper type or size.
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press if the paper was changed.
• Press the arrow buttons until Use Current appears, and then press to print on the paper
currently in the printer.
• Cancel the current print job.
4062
Diagnostic information
158
To Next Page
Loading...
