3 Remove the three screws (A) securing the stapler unit assembly.
4 Remove the stapler unit assembly.
SFP stapler assembly paddle drive motor assembly removal
1 Remove the left cover. Go to “SFP stapler assembly left cover removal” on page 433.
2 Disconnect the paddle motor harness from the controller card.
3 Remove the cable from the harness clip.
4 Remove the two screws (A) securing the two paddle drive motor assemblies.
A
5 Remove the paddle drive motor assembly.
Sensor (SFP stapler assembly media stack) removal
1 Remove the top cover. Go to “SFP stapler assembly top cover removal” on page 434.
2 Disconnect the harness to the sensor (media stack).
4062
Repair information
442
To Next Page
Loading...
