3 Unsnap each side of the deflector and remove.
Installation note: The static brush mylar assembly is attached to the media bin fifth deflector. Do not
forget to reinstall it on the new deflector.
5-bin mailbox media bin extension assembly removal
1 Fully extend the media bin extension.
2 Release the two tabs on the underside of the extension and pull out the rest of the way.
5-bin mailbox deflector gate solenoid removal
1 Remove the 5-bin mailbox right outer cover. Go to “5-bin mailbox right outer cover removal” on page
345.
2 Remove the 5-bin mailbox left outer cover. Go to “5-bin mailbox left outer cover removal” on page 344.
4062
Repair information
354
To Next Page
Loading...
