3 Release the buttons when the screen with the progress bar appears.
Exiting the Diagnostics menu
Note: This is applicable only to models T650, T652, and T654.
From the menu, select Exit Diagnostics to reset the printer. The printer then performs a POR, and returns to
Ready state.
Registration
Configure this setting to make sure printouts are aligned properly.
For models T650, T652, and T654
1 From the Diagnostics menu, select REGISTRATION.
2 Print a test page. For more information, see “Printing a quick test page” on page 237. Retain this page to
determine what changes to make to the margin settings.
3
Configure
any of the following margin settings.
• Top Margin (value: ‑25 to +25)—A positive change moves the image down the page and increases the
top margin. A negative change moves the image up and decreases the top margin.
• Bottom Margin (value: ‑20 to +20)—A positive change compresses the image so it appears to move
down the page and a negative change moves the image up.
• Left Margin (value: ‑25 to +25)—A positive change moves the image to the left and a negative change
moves the image to the right. No compression occurs.
• Right Margin (value: ‑99 to +99)—A positive change moves the image to the right and a negative change
moves the image to the left.
Notes:
• Use the left or right arrow button to decrease or increase the values. You can press the Select button
to reset the values.
• You need to print a test page every time you configure a margin setting in order to verify the
changes.
4 Press the Back button to exit REGISTRATION.
For model T656
1 From the Diagnostics menu, select REGISTRATION.
2 Print a test page. For more information, see “Printing a quick test page” on page 237. Retain this page to
determine the changes you need to make to the margin settings.
3 Configure any of the following margin settings.
• Top Margin (value: ‑25 to +25)—A positive change moves the image down the page and increases the
top margin. A negative change moves the image up and decreases the top margin.
• Bottom Margin (value: ‑20 to +20)—A positive change compresses the image so it appears to move
down the page and a negative change moves the image up.
4062
Service menus
236
To Next Page
Loading...
