5 Remove and unroute the cable to the deflector gate solenoid.
6 Disconnect the proper deflector gate solenoid harness from the controller card.
Installation note: To ease the cable unrouting, cut the appropriate cable.
5-bin mailbox transport solenoid removal
1 Remove the 5-bin mailbox left outer cover. Go to “5-bin mailbox left outer cover removal” on page 344.
2 Disconnect J15 at the controller card.
3 Remove the screw (A) securing the 5-bin mailbox transport solenoid to the left frame.
A
4 Remove the 5-bin mailbox transport solenoid.
Sensor (5-bin mailbox sensor
deflector
gate HP) removal
1 Remove the 5-bin left inner cover. Go to “5-bin mailbox left inner cover removal” on page 344.
2 Remove the following harnesses from the controller card: J14 A and B, J2, and J11.
4062
Repair information
356
To Next Page
Loading...
