6 Remove the laser cover.
T650 LVPS card assembly removal
Warning—Potential Damage: WARNING: When replacing the LVPS card assembly, ensure that the voltage
selection switch is set to the proper setting, or damage will occur.
1 Remove the door assembly, rear. Go to “Rear door assembly removal” on page 327.
2 Remove the side cover, right. Go to “T650 right side cover removal” on page 294.
3 Disconnect the connector (A) from the LVPS card assembly.
4 Remove the two screws (B) from the LVPS card assembly.
B BA
5 Gently pull the LVPS card assembly from the machine.
4062
Repair information
290
To Next Page
Loading...
