• Left Margin (value: ‑25 to +25)—A positive change moves the image to the left and a negative change
moves the image to the right. No compression occurs.
• Right Margin (value: ‑10 to +10)—A positive change moves the image to the right and a negative change
moves the image to the left.
Notes:
• Use the left or right arrow button to decrease or increase the values.
• You need to print a test page every time you configure a margin setting in order to verify the
changes.
4 To uc h Submit to save the changes.
5 Tou ch Back to exit REGISTRATION.
Printing a quick test page
Note: Use only A4‑ or letter‑size paper.
The test page contains the following information:
• Printer registration settings
• Code levels
• Alignment diamonds at the top, bottom, and each side
• Horizontal lines for skew adjustment
• General printer information, including current page count, installed memory, processor speed, serial number,
engine ID, and system card ID
For models T560, T652, T654
1 From the Diagnostics menu, select REGISTRATION.
2 Press the down arrow button until Quick Test with a check mark appears.
3 Press the Select button to start printing.
For model T656
1 From the Diagnostics menu, select REGISTRATION.
2 To uc h Quick Test to start printing.
PRINT TESTS
This test determines if the printer can print on paper from any of the installed trays. Only the installed trays are
listed in the Print Tests menu.
The content of the test page varies depending on the paper in the selected tray. Check each test page from
each source to assist in print quality and paper feed problems.
4062
Service menus
237
To Next Page
Loading...
