Action Yes No
Step 6
Check the printhead installation, and reinstall and adjust the
printhead assembly if necessary. Go to
“T650 printhead assembly
removal” on page 334 or “T652, T654, and T656 printhead
assembly removal” on page 336. .
Does the problem remain?
Go to step 7. Problem is solved.
Step 7
Perform a print test.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Skew check
ABCDE
ABCDE
ABCDE
Action Yes No
Step 1
Check the printer installation placement for installation surface
irregularities. Check the printer caster for any damage. If
necessary, correct the installation placement.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Properly load media into the media tray assembly and set all guides
correctly. Properly reinstall the media tray assembly into the printer.
Does the problem remain?
Go to step 3. Problem is solved.
Step 3
Check the area of the media feed units for obstructions, and
remove them if necessary.
Does the problem remain?
Go to step 4. Problem is solved.
Step 4
Check the transfer roll assembly for contamination and wear, and
replace the transfer roll assembly if necessary. Go to
“Transfer roll
assembly removal” on page 314.
Does the problem remain?
Go to step 5. Problem is solved.
4062
Diagnostic information
52
To Next Page
Loading...
