Transfer roll assembly removal
1 Open the operator panel door assembly.
2 Remove the print cartridge.
3 Gently unsnap the transfer roll assembly from the machine.
4 Remove the transfer roll assembly.
Installation warning: When replacing the transfer roll assembly, do not touch the foam surface.
Left transfer roll bracket assembly removal
1 Remove the transfer roll assembly. Go to “Transfer roll assembly removal” on page 314.
2 Remove the inner deflector. Go to “Inner deflector removal” on page 299.
3 Remove the screw (A) securing the transfer roll bracket assembly, left to the machine.
4 Remove the transfer roll bracket assembly, left.
5 Remove the roll clamp (B) from the transfer roll bracket assembly, left.
6 Remove the bushing (C).
7 Remove the spring (D).
4062
Repair information
314
To Next Page
Loading...
