3 Pull the drive roll gear (B), the shaft with spring (C), and the bevel out through the opening.
A
A
B
C
A
4 Remove the 550-sheet tray option drive shaft with spring.
Anti-tip latch assembly removal
Note: Carefully remove the base machine from the input option tray assembly before proceeding. The left
and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below are for
removing the left latch, but removing the right latch is similar.
1 Remove the 250-sheet media tray assembly. Go to “250-sheet media tray assembly removal” on
page 359.
2 Turn the drawer upside down, and unsnap the two hooks (A) securing the anti-tip latch assembly to the
drawer with a flathead screwdriver.
Note: The hooks might break when detaching the anti-tip assembly from the drawer.
4062
Repair information
370
To Next Page
Loading...
